A.C. Cars Ltd. looking for info

[1ntCobra]

Originally Posted by LMH

Here's a couple more photo's to stir the pot!

Underside of the OP's left front fender showing body seams:


Top side of a Kirkham fender showing body seams:


Seams look to match to me. Further more, most aluminum shapers seam the fenders down the top center. Kirkham seams theirs off center towards the outside of the car.



Here's a photo of the pedal box. Note the open bottom to the box. Original cars don't have a removable panel on the bottom, rather they are solid across the bottom. It was Kirkhams idea to produce their pedal box with a removable panel.


However, It was also Kirkhams idea to bolt their pedal box in on each end of the mounting tube. The OP's car is welded in. ???


Kirkham Pedal box:


Thoughts?
Larry

I seam to recall (or is it seem to recall), that Kirkham has reduced the number of aluminum pieces over time needed to make up their bodies. I may have heard that on this site or perhaps at a Kirkham open house. If that is the case there may be 2 or more variations of Kirkham body seams to potentially match against.