Question about Trigo fia wheels

[Shootnride]

Originally Posted by Cobra #3170

should be running by Friday in case anyone cares.

I do !

Will you be at Good Guys in Pleasanton in June ?

Ted

[MAStuart]

Bruce if it is not too much trouble. Overall width. backspacing, and thickness of the hub of the wheel.

Good luck with your new engine. If you type I read what you type. If I lived close I would be willing to help in any way I could in your car adventures.

Thanks again
Mark

[Cobra #3170]

Originally Posted by MAStuart

Bruce if it is not too much trouble. Overall width. backspacing, and thickness of the hub of the wheel.

Good luck with your new engine. If you type I read what you type. If I lived close I would be willing to help in any way I could in your car adventures.

Thanks again
Mark

I will measure the wheels tomorrow when I go out to garage, too tired tonight.
Old people need their sleep!

[Cobra #3170]

Originally Posted by Shootnride

I do !

Will you be at Good Guys in Pleasanton in June ?

Ted

We are planning on going but will be a completely untested set up. New shock pistons and engine with much lighter crank. We will have to try and tune it there. There are no events to run so I will break in the new diff on the subdivision roads and hope it all works out. I got oil pressure today spinning the dry sump pump, radiator is in, brakes installed, steering rack tied down, all fuel lines reconnected. Power steering pump, alternator and wiring tomorrow.

[Shootnride]

Originally Posted by Cobra #3170

We are planning on going but will be a completely untested set up. New shock pistons and engine with much lighter crank. We will have to try and tune it there. There are no events to run so I will break in the new diff on the subdivision roads and hope it all works out. I got oil pressure today spinning the dry sump pump, radiator is in, brakes installed, steering rack tied down, all fuel lines reconnected. Power steering pump, alternator and wiring tomorrow.

Sounds like you're making good progress. Look forward to seeing you run with the new engine. It should be impressive, the old one sure was.

Ted

[MAStuart]

Thank you Bruce for taking the time to do the measuring in the middle of your engine install. I hope the rest of your install goes smoothly .


With the numbers you provided I am getting a better picture of how thing should be.

Mark