KMS Differential Questions

[cobrakiwi]

David
Just an idea, could you leave material on the inside of the cover (1 inch square by 1/4 or so) where the breather hole is, then drill from the outside in but not all the way through, then from the bottom edge of the square block inside drill two small holes to intersect?

[cobrakiwi]

Or, could a small baffle be made up and tig welded in?
I would think your covers could stand up to two small welds with out warpage.

I have placed many baffles on the steel covers and would think it could be done with the aluminum covers as well.

[patrickt]

Originally Posted by cobrakiwi

I have placed many baffles on the steel covers and would think it could be done with the aluminum covers as well.

I think I could whip one up with the bottom of a beer can and some JB Weld.

[1795]

Here is a picture of what Ross did based on Morris' suggestions to the rear cover of mine and it was an aluminum cover.



Jim