09-02-2020, 08:24 PM
|
 |
Senior CC Premier Member
|
|
|
Join Date: Nov 2015
Location: Bellevue,
WA
Cobra Make, Engine: Everett-Morrison 514, Toploader 4 sp, Jag IRS
Posts: 278
|
|
Not Ranked
As Dan nears completion on the new batch of badges, my badge from the prior batch is 'finally' mounted…!
A custom stainless steel bracket was welded inside the bumper overrider. The bracket was designed to place the badge in the horizontal center of the driver side outer rear hoop, almost floating, with a clean, integrated look.
It’s nearer to the lower hoop bar, so when standing behind the car looking down it's easier to read, not as blocked by the upper hoop bar.
This location framed the badge nicely to stand out, while being both out of the way and protected.
Brent
Last edited by EM-0785; 09-06-2020 at 05:50 PM..
Reason: Add detail
|
47Likes
Threaded Mode
