07-17-2003, 07:19 AM
|
 |
CC Member
|
|
|
Join Date: Dec 2000
Location: Livermore,
CA
Cobra Make, Engine: ERA #629, BBM Side Oiler Block, 482ci, Richmond 5 speed
Posts: 853
|
|
Not Ranked
Robert,
I know what you mean about cutting the wires and getting the ends on properly. I bought the MSD 8mm wires and they give you a nice jig for cutting and securing the wires. You need to use a vise to compress the jig as you crimp each wire but it does a good clean job. I like the spark plug end of the wire too since the plug wire is adjustable to any angle from straight to 90 degrees.
Chris
|
Threaded Mode
