Club Cobra Keith Craft Racing  

Go Back   Club Cobra > Cobra Talk Areas > ALL COBRA TALK

MMG Superformance
Nevada Classics
Keith Craft Racing
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
MMG Superformance
Advertise at CC
Banner Ad Rates
MMG Superformance
MMG Superformance
MMG Superformance
April 2024
S M T W T F S
  1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30        

Kirkham Motorsports

Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 03-28-2004, 12:38 PM
CC Member
Visit my Photo Gallery

 
Join Date: Nov 2000
Location: Pennsylvania, PA
Cobra Make, Engine: SPF 460/535 Titanium Blk. Strpe
Posts: 55
Not Ranked     
Unhappy Squeek in rt rear suspension

I have developed an anoying squeek in the Rt rear suspension of SPF 1094. It squeeks on up and down movement (if I rock it up an down it squeeks in both directions) . I put it on a lift and cannot isolate where it comes from. I tried spraying with silicon lube on springs and moving parts but no help. Any sugestions. It started after sitting over the winter with no use.

Thaks in advance.
Charly SPF 1094
Reply With Quote
  #2 (permalink)  
Old 03-28-2004, 01:31 PM
Tony Aprile's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2002
Location: Long Island, NY
Cobra Make, Engine: SPF #1358 Silver/Black stripes 466 2X4
Posts: 780
Not Ranked     
Default

Charly I had the same squeek, I removed both rear tires and applied penitrating oil around every rubber bushing, after a good drive the squeek was gone.

Tony
Reply With Quote
  #3 (permalink)  
Old 03-28-2004, 04:37 PM
Dan Semko's Avatar
Hoosier Gashole Emeritus
Visit my Photo Gallery

 
Join Date: Jan 2000
Location: Richmond, IN
Cobra Make, Engine:
Posts: 2,292
Not Ranked     
Default

Charly,
Gary Osborne had a similar annoying squeek that drove him crazy. After lubricating the rear bushings, the sway bar bushing etc we finally isolated it to the bushing under the trans mount. The bushing has a metal sleave that had worn through the rubber on the bottom surface causing a metal to metal contact. Try putting your car on a 4 post lift. While you're rocking it up and down, have a friend under the car and place a long flat headed screwdriver on each side of the trans mounts. It will be obvious if that's the problem. If it is, loosen the bolt, use a bottle jack, lift the trans slightly When you pull the bushing out, you immediately see the bare metal area. Place a large rubber washer ( like the one you'd find in a toilet filler replacement assembly) between the surfaces and retighten snuggly.
__________________
DDS/The First Edition

"In debates on ethically contentious issues, it is never wise nor polite to deride or belittle another person's delusion."
Reply With Quote
  #4 (permalink)  
Old 03-28-2004, 04:40 PM
Bob In Ct's Avatar
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Mar 2001
Location: Southern Connecticut, CT
Cobra Make, Engine: SPF - 351W, 944 non-turbo
Posts: 2,105
Not Ranked     
Default

Charly:
Same problem with SPF642. I sprayed liberal quantities of silicone (not WD40) on all the bushings and joints and the squeak went away.

Bob
Reply With Quote
  #5 (permalink)  
Old 03-29-2004, 05:23 AM
Club Cobra Member
Visit my Photo Gallery

 
Join Date: Feb 2003
Location: Sterling, IL
Cobra Make, Engine: SPF #1507 427 Dart Block Windsor
Posts: 1,192
Not Ranked     
Default

Charly,

It might sound like these guys are suggesting a backyard fix, but on page 35 of the owners manual, it does say to use "...liquid wrench or similar penetrating oil/lubricant" on the suspension bushings. I give 'em all a little squirt every time I have the car up for greasing and service. If that's not it, you may have to use Dan's toilet tank washer trick. Please let us know what you find.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 07:16 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink