07-11-2007, 08:29 AM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Erson Roller Rocker Adjustment Question
Neither the little 7/32" hex locknut in the middle, nor the the larger 5/8" adjusting nut, will budge using all the hand strength I can muster. Before I break out a larger tool, is there anything unusual about the Erson roller rockers that I should know about? That little 7/32" hex locknut in the middle essentially just "clicks" on and off to lock the adjustment, correct? And just how much torque should be on it? Here's a shot:
 |
Threaded Mode
