01-09-2009, 10:03 PM
|
 |
CC Member
|
|
|
Join Date: Jun 2000
Location: Cape Town, South Africa/Mainz, Germany,
Posts: 1,601
|
|
Not Ranked
concentric?
Nice going! :-)
Please can someone fit the pins on a stud or bolt and turn them in a lathe or drill press.
I would like to know if they are concentric. Or how much they "run out".
You could also fit them (2) on a hub. Measure the gap with a vernier caliper between the two. Then turn them half a turn and measure again. Do that until you get the biggest difference.
Dom
__________________
If I don't respond anymore, that's because I can't log in
|
Threaded Mode
