03-21-2009, 01:22 PM
|
 |
CC Member
|
|
|
Join Date: Jun 2006
Location: Merced,
Ca
Cobra Make, Engine: West Coast-Ford Performance Solutions 533 BB
Posts: 390
|
|
Not Ranked
Inner baffle size
Yes, the OD on the exhaust pipe is 3 1/2" and into it inserts a long 2"? ID multiply perforated pipe with a 3 1/2" multiply perforated flange at the engine end, a 6" long solid flared cone towards the rear, and fibreglass wrapped around the length of the baffle about 1/2" thick. Do you think it's too restrictive?
You know, I thought it was a 2" ID inner baffle pipe, but haven't seen it since I installed them a while back, perhaps I misremember the spec....I bet it's 2 1/2" ID baffle and I was wrong in my post Car's at the upholsterer's atm so I can't check til next week.
Dirk
__________________
The government giveth and the government taketh away..... if our rights are not God given then they're subject to revision!
Last edited by DocDirk; 03-21-2009 at 01:26 PM..
|
Threaded Mode
