Cage / Door bar pictures?

[ItBites]

Thx Jeff. I like your setup. I put a tube in mine where I think the door bar will have to go and when turning left (simulated, with vroom noises) my elbow hits the bar (partly because of the seat side bolsters - Kirkey intermediate road race seat). I hate to try to track the car if I have to keep my elbow above the door... I may have to gove up on the door bars, or lower it more than I wanted to. Anyhow, thanks alotly.

Any others with a cage or door bars? I know yer out there!

[rschoeni]

The fabrication is much like Jeff's as far as the knee bar and door bars except I located the forward end of the doorbars at the floor, welded to the base of the forward halo down bars. I have a diagonal in the main hoop, a harness bar, and overhead diagonal in the halo. The harness bar allows you to add a back brace for your aluminum seat. The seats are mounted so that the butt contacts the floor. I like to sit low.

I used 1.5" 0.120" wall chromoly. Because of the limited space in the cockpit, because I didn't gut the doors, and because I wantto be able to fit one of Bruce's Lemans tops over the cage, it is a compromise. It's compatible with the wind screen.
_____
/bs

BobSchoeni
FFR 347ci

[twin turbo]

Here is mine.