Two different motor mounts?

[PNJSNAK]

Wakeen 19
Did you mount the motor mounting brackets supplied by A&C to the frame?
If so, how did you know where to put them?
I used the motor, motor mounts and the frame motor mounts to position the motor on the frame.
I needed spacers between the frame mounts and the frame.
Also, I think my motor is 1/2" offset to the passenger side.
If I remember one spacer was thicker than the other.
Jim

[wakeen19]

I used the supplied frame mounts and the engine mounts from mustangs unlimited. I measured 22 1/2" from the top crossmember back to in between the top middle two header pipes on the block.

If I split the difference between the frame rails, I am still about 3/4" away from the frame to the A and C mounting bracket.