08-10-2010, 11:43 PM
|
CC Member
|
|
|
Join Date: Jun 2006
Location: Newcastle, Warners Bay,
NSW
Cobra Make, Engine: RMC . 393 Dart alloy block Stroked 351 alloy heads ..all the goodies plus a pre oiler. al
Posts: 1,495
|
|
Not Ranked
That's scary with the roll cage mounts and the comments on fitting them...cut a hole in the floor to lower the cage to weld it then weld a thicker plate over the hole....In all the books I've read the roll bar should be mounted on a chassis member or sandwich plated to a structural member ie:- the sill or pillar frames...It looks like this particular roll bar was installed so they didn't damage any interior trim. How did they get out ? through the boot ?
|