347 cube Dart motor for sale

[750hp]

A member in the Qld Cobra Club is selling his 347 cube motor. It was built in 2010 and has covered a street miles and some track days since. It's not brand new, but it has a whole lot of life left in it.

Dart SHP block
Scat 4340 steel crankshaft 3.25" stroke
Scat 4340 I-Beam rods
SRP pistons 4.125" bore
Edelbrock Performer RPM heads
Ferrea 5000 Series valves
Isky springs
Isky retainers
Crane Gold Series roller rockers
Crower Hyd Roller cam Part 15514
(Dur @ .050" 234/240, Lift .533/.540)
Edelbrock manifold
Holley carb
Mallory Unilite points distributor
Cobra finned rocker covers
K&N XStream filter
Total Seal file fit rings
ACL bearings
Clevite oilpump
ARP drive
Rear sump
FoMoCo alum water pump
Balanced flywheel

Compression test is even across all cylinders

He will take it out of the Cobra if he gets $8000 for the lot, otherwise it stays in there.

Therefore, it's for sale for $9000 negotiable

Denis doesn't get onto this site and I'm not a fan of posting email and phone details online. If you're keen, shoot me a PM and I'll get you in touch.

[750hp]

One and only bump to the top to make sure everyone has had a chance to see this engine for sale.
Price drop to $7500 to move it on.

[Mrs flatchat]

Hmmm, that motor looks familiar ---and to think that he'd try and hose off my no brainer 302 with it tch tch -- the wylie old bugger

[750hp]

Like many guys in the club.
"Just a stock 302 with a 4 barrel and a good air.filter"

Yeah right...

[spookypt]

Craig that sounds like mine....without the good air filter.

[750hp]

Spook, you must have a dud plug lead or two, because yours runs a bit rough at idle for a mild small block...

[Mrs flatchat]

Urrh, OK its a 303.85 ci and a small air filter