09-23-2014, 08:12 PM
|
 |
CC Member
|
|
|
Join Date: Jan 2001
Location: Sunbury,
VIC
Cobra Make, Engine: Rat Rod Racer, LS1 & T56
Posts: 5,391
|
|
Not Ranked
Quote:
Originally Posted by PeterAllen
On my LS1 setup the bellhousing on a t56 is approx 12mm lower than a C6 sump.
|
I've found this too with mine. The current plan is to mill the bottom edge of the bell housing flush with the sump.
I'll post some before and after pics.
I had the Camaro sump on my CR before and it was the lowest point in the car. Switching to the C6 pan gained about an inch of ground clearance. Milling the bell housing will gain a little more again.
Cheers
__________________
Mike Murphy
Melbourne Australia
|
6Likes
Threaded Mode
