BIG Brakes on a small budget

Philm · #1 (**permalink**) 04-25-2006, 08:37 AM

HI Mike,
That is a good set up, I have done the same but I got some hubs made from Hoppers stoppers for $400.00 included bearings and seals.

I used the 343mm HSV rotor, 2 piece and a Wilwood caliper.

I also took the opportunity to change the front stud pattern and center bore to ford.

Phil

Aussie Mike · #2 (**permalink**) 04-25-2006, 04:22 PM

Hi Phil,

Your setup was part of the inspiration. I spoke to the guys at Hoppers but I believe their hub was a different offset to what I wanted. I also wanted the spiggot to better fit the pin drive adaptor. If I didn't already have my wheels I probably would have gone that way and changed the stud pattern too.

Cheers