Engine Shiny Bits

[dbn04]

PETER,
i took water pump pulley, alternator, several brackets to a plater only cost $170 for the lot,
darren

[Philm]

HI Peter,
I am not definitely sure if all windsors are the same, there my be different offsets and it depends if you have a 3 bolt or 4 bolt harmonic balancer.

Most sites would have dimensions you can work with.

I actually went for a gilmer set made by diecrest engineering for a 2 piece crank pulley, one to drive the alternator and one to drive the powersteering pump.

I made the brakets out of alloy and had them polished.

This sort of stuff is pretty hard to get, there are plenty for small block chevs though.

Phil

[PCC]

Darren

Who was your Plater and how are they standing up (any peeling)?

[dbn04]

only had it done a few months ago , all good so far. it was a local guy in maroochydore. if its not to far for ya i can get the details

[PCC]

Quite fancy nico electroplating, but unsure who does it here in Brisbane.

Looks like stainless steel with a hint of gold and apparently stays as when it was coated.

Has anyone had any experience of such a method?

Thanks Guys