02-07-2008, 02:47 AM
|
 |
CC Member
|
|
|
Join Date: Jan 2007
Location: Melbourne,
VIC
Cobra Make, Engine: Harrison, 6.0L Chev
Posts: 2,513
|
|
Not Ranked
Quote:
Originally Posted by macloft
Hi Sambo
Warrick sells the splined connecting shaft and appropriate bottom uni the top one I used is the laser. As Darrell said use a flat blade driver to open the uni up to fit the shaft. I only have two unis one on the end of the laser column and one connecting to the steering rack. Will you have a uni in the middle to?
My connecting shaft is 16mm dia. I would lathe down your 3/4 stainless rod at the steering column end and spline it to fit the laser uni.
|
G'day Bruce. I think because I went with the VK power rack Warwick wasn't able to supply the lower uni. The Laser uni fits fine, no screw driver needed. Ideally I would like to machine the end of the column if it's physically possible and so long as it doesn't overheat the bearings. Then I've got new, serviceable u-joints and 3/4" all the way from the top uni to the rack.
And yes I have the same setup as you: steering column, uni, connecting shaft, uni, rack. |
1Likes
Threaded Mode
