Wiring

ndpace · #1 (**permalink**) 03-29-2010, 08:42 AM

After looking everywhere it looks like my B&B manual and CD were in my bag that was stolen from my car the day before christmas. Do either of these cover the wiring? I wanted to see if I should replace them.

I am wiring up the lighting and had some questions. I have the Pro-T wiring system paperwork. I have 4 of the round L692 tail lights. Each have a black, red, and green wire. How do these wire to my BROWN tail lights, Green right rear, and yellow left rear. What do the upper and lower lights each do.

Thanks, Jim

ndpace · #2 (**permalink**) 03-31-2010, 02:20 PM

I did not get any replies to my original post, so I wanted to see if the CD or manual has a wiring diagram in it. If so could someone sent it to me electronically? I really want to get it wired.

Thanks, Jim

Bryan Anderson · #3 (**permalink**) 03-31-2010, 02:45 PM

send me an e mail over to bbmfg@jscomm.net with your address and I will mail over a complete haywire wiring diagram for you.

Bryan
www.bandbroadster.com

ndpace · #4 (**permalink**) 04-13-2010, 04:58 PM

which is the brake light (upper or lower)?
which is the turn signal (upper or lower)?
which is the running light(upper or lower)?
I have the 4 round tail lights.

Thanks, Jim

Wbulk · #5 (**permalink**) 04-18-2010, 06:42 PM

Jim, if you find out the answer to this question please post it. I am about to that point also.

Wayne

Bryan Anderson · #6 (**permalink**) 04-19-2010, 03:05 PM

Jim, we wire all four light for the brakes and that also has both lights on for the turn signals as well and running light are all four lights also, I hope this helps.

Bryan

ndpace · #7 (**permalink**) 04-19-2010, 03:25 PM

Thats almost everything. Each bulb has two filiments (brighter and dimmer) what goes to each specific filiment?

Thanks, Jim

ron427 · #8 (**permalink**) 04-19-2010, 06:57 PM

Jim
I have B & B also and happy with it. Bryan is a good man to know as he is always helpful..Go with turn wires to bright side on each light. Good Luck Ron

ndpace · #9 (**permalink**) 05-12-2010, 10:35 PM

so I have some power to the turn signal lighting wires but they do not blink and I do not hear and relay clicking. How should that be wired?
Thanks Jim

trularin · #10 (**permalink**) 05-13-2010, 05:01 AM

If I may, why not wire the lights like a trailer ( wiring and color code can be found anywhere )?

Buy the four wire HD harness for $10.00 and run the wires across the back of the car. Three to the left and three to the right. There are two common and two unique ( left and right side ).

If ever you have a wiring problem, you cna find information anywhere if you wire it up like trailer.

Just a suggestion.