Correct Pole Length on bumpers (quick jack) Question

[ZeremiaH]

BDR#231

I've tried to search a lot on this subject but I'm currently spinning my wheels on info. So any info on this would be much appreciated.

I'm replacing my bumper overriders with the quick jack bumpers, and got new mounting kits/poles from shellvalley instead of the aluminum poles from BDR. Didn't think the length would be too off, but the ones from shellvalley are longer then my original poles. I feel the back bumpers sticks out farther. However from backdraftracingparts the aluminum poles they sell are even longer then the shellvalley ones.

Was wondering if someone that has quick jack bumpers measure from the body to the quick jack bumper? or if someone knows the correct length from the body to the bumper? I say from body to bumper only because the mount points might be different from inside the gas tank/trunk area. So I don't need to know the total length of the pole just length from body to bumper. If this makes sense.


My original poles length: 4inch total back, 7inch total front.

Thank in advance.

[csw]

I have BDR 949 and the quick jack measurements are:

Front top: 2" on outside (the side closer to tires since they sit at an angle) to the black grommet
Front bottom: 2.5"
Back top: 1.5" from body
Back bottom: 2"

[ZeremiaH]

Originally Posted by csw

I have BDR 949 and the quick jack measurements are:

Front top: 2" on outside (the side closer to tires since they sit at an angle) to the black grommet
Front bottom: 2.5"
Back top: 1.5" from body
Back bottom: 2"

Thank you so much. Looks like I'll be using my old tubes then.