Kirk! We're under attack!! Suspension help.

[markantioch]

To remove the stock CR sway bay with the body mounted and the vent cone in place. Must the bar be cut, so it could slide on out?

[Sycraft]

Originally Posted by markantioch

To remove the stock CR sway bay with the body mounted and the vent cone in place. Must the bar be cut, so it could slide on out?

I had to disconnect the DS tie rod from the spindle and have the car on a lift, then I was able to remove the sway bar in 1 piece, I was almost ready to cut it in half... But with persistence it came out.

[markantioch]

My nose cone shroud is tightly cut around the sway bar. Was yours a loose cut/fit, or was it cut to fit with a small gap around the bar? My intent is to get it out without having to cut the sway bar, or opening up a large gap around the sway bar on either end.