Interior Door Panel Replacement

[ATXCobra]

Has anyone had to replace the door panel on the passenger side in their CR? Mine is looking a bit worn out. I'm wondering if a standard panel will fit or if the CR cars have longer doors with the extra length? I found these at Shell Valley but when I contacted them, they were pretty sure they wouldn't fit.


https://www.shellvalley.com/index.cf...rod/prd111.htm

[letsboogie351]

Go and see your local motor trimmer. I'm sure he/she could help you. Either make a new door card or re trim both existing.

[MaSnaka]

Upholstery shop should be able to make you something similar. I doubt those SV units would fit. I need new ones too.

John

[Chicagowil]

The only other door car even close is on an Excaliber- but still different.

Do you have the plastic style door card base? It would be pretty easy to have a car/RV/Boat upholstery shop redo the door cards.

I just installed my cards last week. My car is a CR1. It has the plastic base with a thin sheet of foam and the skin over that. The holes for the plastic insert style clips had never been drilled. That was the hardest part.

I also added the leather door stops that FFR sells for their Roadster.

I had my dash recovered last month- it was $500. She had to clean up the fiberglass a bit more after I removed the cover. She added a thin foam under the black covering. I think it turned out nice.

I should get the dash installed this week. Just finished the carpet today. And then the seats go in.

[Chicagowil]

Here are a few shots of the door cards & seats installed as well as the carpet.

The carpet & seat colors came with the kit.

I was very reluctant to use the carpet until I saw the recent AC sold in the UK came with this same color!

And, it somehow works OK with the Viking Blue.

If I get tired of it, I can take them out to be redone easily. As I stated before, I already had the dash recovered in black.