Need CR Headers for SBC 350

MaSnaka · #1 (**permalink**) 10-26-2009, 10:25 PM

Snipes...You do realize the thread your replying to is more than 6 years old. State your location and I'm sure someone could steer you in the right direction. CR is out of business but there are other sources. I would think any specialty exhaust fab shop could make you some.

John

Hotfingrs · #2 (**permalink**) 10-27-2009, 03:28 AM

You're gonna have to get them made. I wouldn't go to an exhaust shop, unless you really knew the persons work. Find someone in your area that does custom rods and such and they will be able to make a nice set. Of course you're gonna have to have the car pretty much together so they can do it.

snipescastle2 · #3 (**permalink**) 10-27-2009, 06:23 AM

Fellas's,
Thanks for the info, guess I better start looking at dates on these messages! I have found a few places that are willing to make a set, Dana Dankert from shell valley said he can do it, I'm most likely gonna go that route. Reasonable prices too, If I remember correctly, he said roughly $450 a set. Thanks again!
Ben Smith

Oh yeah, I'm in Warrensburg, Missouri close to Kansas City