Welcome. There are plenty of people here in your state, but Texas is so big, I don't know how close. Also there is a FFR website in addition to this site. I'm sure you will find a lot of people willing to help out.
Get some real good drill bits for riveting the panel on. It will make life easier, but if you need more exercise use dull bits.
Cobra Make, Engine: FFR3542K, 347 C. I., EFI, T-5, Miata Front Sway Bar, 3 Link, Red with White Stripes
Posts: 1,181
Not Ranked
Bob,
Where in Texas are you? Lots of Cobra guys in our state to help you out.
__________________
Steve
Texas Cobra Club-Seguin
July 2009 FFCars Picture of the Month
FFR3542K, 347, Holley Sniper EFI, T-5, 4 Wheel Discs, 3-Link, Miata Front Sway Bar, Red with White Stripes
Cobra Make, Engine: Butler...488" hi-rise, dry-sump FE s/o w/stacks
Posts: 543
Not Ranked
Steve, he said Bulverde. Looks like it is north of San Antonio on 281 and southwest of Canyon Lake....about midway between the two.
Bob, welcome to Club Cobra. For a Factory Five, you are going to find more help with questions about the kit on ffcars.com. That forum is 95% Factory Five.
But, you are always welcome here anytime. Welcome to the madness
__________________
Russ
Last edited by SoTxButler; 07-13-2010 at 08:16 PM..
Reason: mistake
Welcome. There are plenty of people here in your state, but Texas is so big, I don't know how close. Also there is a FFR website in addition to this site. I'm sure you will find a lot of people willing to help out.
Get some real good drill bits for riveting the panel on. It will make life easier, but if you need more exercise use dull bits.
just get a drill bit sharpener, cuts down by a lot on the # of bits required plus it is readily available anytime and it comes in handy after your done. Sears has a decent one.
Sears has a decent one.
Hybrid Mode
