rear license plate bracket

[kevinson65]

On my car, I made two vertical stainless plates 3/16" Thick x 3/4" wide to bolt to the bumper and tapped each one 4 places: two for #10-32 stainless oval head screws coming through the bumper tubes (from front to back) and two 1/4"-20 for license plate bolts.

On a friend's car we did the same but he didn't want to drill his bumper so we used rubber insulated Adel clips around the bumper

[mvanhorn8893]

I couldn't use the bracket I bought from Finish line due to the recess on the Contemporary deck lid so I made a bracket to mount the plate to the trunk handle and it clears the light and handle nicely without trimming the license plate.

http://www.clubcobra.com/forums/pict...ictureid=19848