02-23-2023, 12:18 PM
|
|
CC Member
|
|
|
Join Date: Apr 2021
Cobra Make, Engine:
Posts: 567
|
|
Not Ranked
I also have a "jag" type rear end and have sheared a pin or two. Finally realized that the problem was that the pins were longer than the depth of the holes in the backside of the wheel. Once I measured the depth of the hole and the length of the pin, I had an easy fix by just shortening the pins appropriately. I checked all four wheels and found the problem only on the rears. My 2˘
|
5Likes
Threaded Mode
