07-12-2004, 07:50 PM
|
 |
CC Member
|
|
|
Join Date: May 2004
Location: Palm Coast,
FL
Cobra Make, Engine: Shelby American CSX 4241 - authentically built
Posts: 2,573
|
|
Not Ranked
Which Parts?
David, can you answer the following questions...
Which toploader bellhousings from the ID chart on your site can be used with an FE motor in a Cobra? It looks to me that the "correct" Cobra bellhousing is the C5AA-A? Is this right? And what other ones will work?
For the trans, it looks like the HEH-BY is the proper Cobra toploader. Will any FE toploader work as long as it's a close ratio, 28 spline?
Is it true that a Tremec TKO will bolt up to a toploader bellhousing? I was told this to be true, but had never heard it before.
I have a 4000 series Shelby on order, and am trying to figure out what trans I want to run. I want the toploader for correctness, but lots of toploader guys who've switched to 5 speeds say it's the way to go. I just don't like the look of the Lakewood bellhousing, but if I can use a TKO with an OEM toploader bell, I think that's what I'd do. Any input would be appreciated. Thanks!
Sal
__________________
Sal Mennella
CSX 4241, KMP 357 - sold and missed, CSX 4819 - cancelled, FFR 5132 - sold
See my car at CSXinfo.net here >> CSX 4241
|
Linear Mode
