Oil Pressure fitting for FE

[Turk]

Bob Putnam
I am at a point where I am installing the oil pressure line to the adapter on the block. I could swear I read somewhere something about the thread size for the screw in portion of the sender. I can't find it. Was it in the manual? If so what page?

Can I just tap the adpater on the block to the same size? Any adapters out there for it?
Help

TURK

[Bob Putnam]

The fitting in the top of the oil filter housing is 1/4 NPT. Your oil line probably terminates in 1/8 NPT. You should be able to find one at an automotive or plumbing supply store.

[Turk]

Bob P.
It was dissapointing to get such an incomplete kit car from you guys.

I thought for shure it would come with at least a few gallons of gas, and oil and antifreeze.
Do you realize how much that stuff costs here in California?

I haven't checked yet but I am beginning to think, I also have to provide the drugs I will need during the carpeting of this automobile.

Last week I ALMOST got Peter talked into walking me through the carpeting step by step.
Should I?

Neah, I'll cut him a little slack. Tell him, I sent an email to you wanting to know which side of the carpet the glue should be applied.
If you can do it with a straight face I would appreciate it.

TURK