10-20-2010, 12:40 PM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Quote:
Originally Posted by RodKnock
Personally, I would sell the car. Too many issues.
|
I'm shocked you're not praising me for having the eagle eye to have spotted this before it left me stranded. 
Quote:
Originally Posted by cdnus
Those little buggers will cut almost anything steel, but are VERY fragile.
They will explode in a heartbeat if jammed up at all, be sure to wear protection  (for your eyes ) 
If you have access problems with the dremel, have a look at the cable drive attachment. It will get in much tighter places.
Craig |
Got it. I think I'll have plenty of room once I remove the master cylinder, and I think I would probably do that anyway to get that plastic inlet on the top of it. Uhhh, I guess I should take pics? 
EDIT -- Cable Drive, hmmm... Man, I love an excuse to buy a new tool.
Last edited by patrickt; 10-20-2010 at 12:45 PM..
|
Hybrid Mode
