04-28-2015, 06:48 AM
|
 |
CC Member
|
|
|
Join Date: Dec 2006
Location: Southbury,
ct
Cobra Make, Engine: ERA, 428, 4 speed Toploader, Jag rear, Red with White stripes
Posts: 938
|
|
Not Ranked
Quote:
Originally Posted by DanEC
Against ERA's recommendations, I'm running 27 inch tall 70 series tires on my front and when first set up my left one rubbed a little on the bottom of the lip where it is rolled under. I ground a little on the lip to angle the inside edge back a little and just barely cleared. But by the time I set the suspension height and aligned the front, I ended up with good clearance. It's not noticeable.
Is this the same place yours is rubbing - at the lower roll under for the rocker panel? Can you just grind the edge of the lip back slightly, contour it and touch up the edge with some paint? I think the body update came between our cars so mine may be slightly different in that area.
Here was the bottom of my fender lip showing the contact before I did some grinding.
 |
No Dan, not even close. I am 5" above your location (see pics I just took).
I also have a little damage to the Pass side, but nothing like this.
I am running BFG 235/60R15. I believe this is what is called out for by ERA.
__________________
ERA#698 428, 4 speed Toploader, 3:31 Jag rear
|
1Likes
Threaded Mode
