I seem to have some albeit small amount of play in my rear hub. I would like to turn the castle nut some and check its torque. Anyone know the size and torque poundage?
I seem to have some albeit small amount of play in my rear hub. I would like to turn the castle nut some and check its torque. Anyone know the size and torque poundage?
Phil
The rear hubs are allowed a small amount of play, I think .004 or so. The end float in the Jag hubs is not a product of the tightness of the castle nut, but is created with spacers. I'll try to double check the torque spec when I get a chance.
10-4. Mine seems like it has 1/4 inch of play in it when I pull on it which is more than the other side. Given that is there a shim that would tighten it up?
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 21,897
Not Ranked
Quote:
Originally Posted by Large Arbor
10-4. Mine seems like it has 1/4 inch of play in it when I pull on it which is more than the other side. Given that is there a shim that would tighten it up?
Phil
A quarter inch of hub end float is a huge, huge, huge amount. Are you sure that when you pull on the wheel you're not being fooled and it's really coming from the u-joints and fulcrum area and maybe the differential output shafts, maybe all added together? Setting the HEF is pretty straight forward, albeit a serious PITA. Shorty instructions can be found here: Setting the Hub Carrier axle bearings but I honestly don't think you have a quarter inch of HEF.
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 21,897
Not Ranked
Quote:
Originally Posted by Large Arbor
Yes, I went back and looked and it appears that its not hub float but just U joint and fulcrum area. Put the tire back on and it appears ok.
Phil
Well I'm glad you didn't break out the impact gun and torque that hub bolt down to ehhhhh, a good 600 ft/lbs. Sometimes just leaving something alone is the best repair of all.
Rear Hub Nut Castle Bolt
Are you sure that when you pull on the wheel you're not being fooled and it's really coming from the u-joints and fulcrum area and maybe the differential output shafts, maybe all added together? Setting the HEF is pretty straight forward, albeit a serious PITA. Shorty instructions can be found here: 
Linear Mode
