ERA FIA bottom cooling hose pictures

[strictlypersonl]

Pete,

I like it! The only thing that gives me pause is the rubber's proximity to the anti-sway bar. Hate to have it rub through. I'll check it out.

[Pete Munroe]

Bob,

Another photo, this one from the top. About 10 minutes of cropping and chopping the photo is down to about 38KB...any smaller and these photos are not much help.

I was more concerned about the rubber hose rubbing against the radiator than the sway bar...sway-bar paint is nice and smooth so abrasion hasn't been a problem so far. Did it 2002? or so...at about 13K miles.

With a little care the hose won't really touch either the sway bar or radiator.

The parts number for the Dayco is a Kragen store brand number I think?...my notes...ink dissolved by adult beverages...are a little hard to read.

Kragen c) 71308 cs The Gates number is #21576 I am sure.

Pete

[Broadsword]

Originally Posted by strictlypersonl

Pete,

I like it! The only thing that gives me pause is the rubber's proximity to the anti-sway bar. Hate to have it rub through. I'll check it out.

Hi Bob,

I see your reply to Pete’s solution for LH inlet water pump 10 years ago...
I’m now the owner of ERA FiA #2009 (in the U.K.!) and I have the same question that birddog asked you regarding an updated hose for RH inlet water pump that will do away with the 90 degree elbow.
What do you recommend for RH pump hoses now please?

Thanks and regards, Martin.