03-13-2012, 05:08 PM
|
CC Member
|
|
|
Join Date: May 2011
Location: Raleigh,
NC
Cobra Make, Engine:
Posts: 17
|
|
Not Ranked
TKO and 6056 bellhousing - not enough room for fork
I am having a lot of trouble with getting enough space between the throwout bearing and the pressure plate. I installed a McLeod 360802 pressure plate and 260571 disc. It's a quick time 6056 bellhousing. The clutch fork is a 7515 ford. I have the pivot ball at it's bottom most point and yet I cannot get more than 0.050 clearance and that's with the fork pushing up against the bell housing. I've talked to a few vendors and everyone seems to be stumped as to why I'm having this issue. Hopefully someone here has seen it, or will recognize a dumb mistake on my part. Any and suggestions would be greatly appreciated.
|