02-05-2018, 12:24 PM
|
|
CC Member
|
|
|
Join Date: Dec 2001
Location: Louisville,
KY
Cobra Make, Engine: I'm Cobra-less!
Posts: 9,417
|
|
Not Ranked
Phil's comment is probably the source of a lot of pushrod-frustration.
Depending on the lifter, sometimes the pushrods don't end up centered in the bottom of them and it's a chore to keep all the rocker arm adjusters on the pushrods at once when you're sliding a rocker assembly on.
When I assemble, I put assembly lube on the lifter ends of the pushrods, slide them through the intake, then take a pen light and make sure they're all down inside the lifters.
|
6Likes
Threaded Mode
