FE solid roller?

[eschaider]

Originally Posted by Dwight

eschaider do you know Blair Patrick?

I live about 150 miles from Blair. I have been to his shop a couple of times with a buddy. I do not know he could bore my block. I will call him tomorrow.
I have five other shop I am contacting.

Thanks

I don't Dwight. I was using Blair Patrick as a source because Brent had identified him as a shop with the capability of boring the oil galleys in the block. I believe the machinery needed to do a deep hole drilling job ike that is relatively rare. Additionally if someone with engine building experience has the equipment he should be a better choice that just a shop with the equipment.

Brent is fairly conservative so I place a high value on his commentary. A 150 mile drive to Blair Patrick's is probably worth the effort. There are not many shops capable of that type of work. A visit can be the equivalent of a picture and easily worth more than a thousand words.


Ed