10-28-2022, 10:50 AM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Quote:
Originally Posted by davids2toys
I have heard those 2 motors have a different requirement than a 428? If they will work on the 428 I think I would get the ST street high performance for 169.00 or the SS Race for 246.00. Brent did not mention this one however. Looking for some solid bolt on recommendations and why. Thanks...Dave
|
Brent L. can answer definitively, but it was always my understanding that all FE balancers will swap out with one another. Early balancers are smaller and lighter than the later ones but they will all fit if you use the right pulley. Balancing is not an issue so don't think about that. Now, when I swapped my ROMAC in for the POS balancer that fell apart my timing marks were about 7 degrees different. I've read that this is a common problem known throughout the industry but that no one really gives a crap about it so it never gets fixed.  |
1Likes
Threaded Mode
