spark plug wire seperaters

[Michael C Henry]

I have the Ford 427 sideoiler. It has the Red Mallory cap and wires.What is available to route and seperate the spark plug wires and secure to the Ford valvecover tab?

[Rick Parker]

Mike I was looking at this very thing for my small block early this week, but reconsidered what I was doing before I completed it. I was needing something for 8.5-9mm wires. I found some 8mm separators at Pep Boys but they were intended for a tab that was about 1" long which is shorter than the tabs originally installed on the valve covers. I think that Ford themselves may offer some plastic separators for 8mm wires as it apears that I have accumulated 1 in my collection.


Rick

[GEORGE ANDERSON]

Michael...call me...if this is what you need...
George

Black V/C Tabs

[My427stang]

With 8 mm wires, I take a 5/16 cutter in a dremel, not a stone, it just makes a melty-mess and a drill will break the piece. And open each hole in a stock Ford one. It wont go bigger than that there isnt enough meat, but 8 mm works well.