04-16-2015, 08:41 PM
|
|
CC Member
|
|
|
Join Date: Sep 2003
Location: memphis, tn,
Posts: 7
|
|
Not Ranked
8 stack system
I have put an 8 stack system on a 351 cleveland. It is dyno tuned and put out 602hp/524tq. My question is this, while on the dyno we just looped a piece of rubber fuel line from one fuel rail on the front to the other. this of course looks... well lets just say not good. I was wondering if anyone had a better mouse trap. It was suggested to cap off the front of the fuel rails and put a T in the supply lines to feed back to the fuelpressure regulator and on back to the tank. That would involve 2-Y splitters, 2-T's and extra fuel lines. this would be a bit busy for my taste. I saw something on a momar injection system picture, that looks like a fuel block that connects the two fuel rails and also had a port for a fuel pressure regulator. the fuel rails are 1.25 inches center to center and too close for bending -6 tubing.
Suggestions??
|
1Likes
Threaded Mode
