Club Cobra GasN Exhaust  

Go Back   Club Cobra > Club Forums > Las Vegas Cobra Club

Nevada Classics
MMG Superformance
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
Keith Craft Racing
Advertise at CC
Banner Ad Rates
MMG Superformance
MMG Superformance
March 2024
S M T W T F S
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31            
  #1 (permalink)  
Old 08-12-2008, 05:35 PM
CC Member
Visit my Photo Gallery

 
Join Date: May 2005
Cobra Make, Engine:
Posts: 33
Not Ranked     
Default Electrical in Vegas (Factory Five)

I am looking to finish up the electrical (EFI302)in the car since the motor is dropped. There are some wires coming from the main harness that I am not sure and just need to install the gauges etc.

Anybody in the Vegas area that could come by and take a look. I am not looking for work done, just guidence to finish the rest of it. I have the engine harness in, rear wires ran.

If the person is qualified, I would entertain paying for their services to finish this up to get the motor turned over.
__________________
Soon to have 500 HP in Spec Racer
Reply With Quote
  #2 (permalink)  
Old 08-13-2008, 04:02 PM
Paul Gillespie's Avatar
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Apr 2001
Location: Glendale, AZ
Cobra Make, Engine: FFR 1574 331 Blown
Posts: 339
Not Ranked     
Default

Here is what I did, I bought a new engine harness from the folks at Mass Flo. http://www.mass-floefi.com/EFIwiring.html
I didn't want to take a chance on a bad wire causing a major failure with my supercharged engine, besides I broke about 90% of the connectors on the old harness. If you get this harness you will have to unwrap part of the harness to change which side the coolant temp sensor and the Air temp sensor is on. On the Mass-flo Harness the Air temp is on the passenger side and the Coolant temp sensor (for the computer not the gage) is on the driver side, the EFI Mustang intake the are opposite. I didn't catch this until I had was ready to plug it in, I was able to pull the wires back and change sides with the harness and the engine w/o upper intake in the car.
__________________
Paul
AZ Cobras
Reply With Quote
  #3 (permalink)  
Old 08-14-2008, 07:06 PM
Doc_Naughty's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Oct 2003
Location: Lost Wages, Nevada, NV.
Cobra Make, Engine: Factory Five, 302 EFI
Posts: 83
Send a message via Yahoo to Doc_Naughty
Not Ranked     
Wink Efi302

NVJoker,

Come by the "Cars & Coffee" car show Saturday morning and you can look at mine and probably Larry's Cobra. We are both EFI-302's.

I also have wiring diagrams for the EFI harness that are pretty accurate. I used them to do mine when I "modded" the original factory harness to do what I wanted it to do. I've deleted all smog related equip and although I have mechanical gauges, I can help you along with the electrical ones.

Cars & Coffee is in the Sansone Park Plaza, just south of the 215 BeltWay, on Eastern Ave. between Serene and Silverado Ranch Rd. --> from 7:00 to 10:00 Saturday morning.

Doc (Pete)
FFR3712 in Lost Wages Nevada
"POPSDRM" on the plate
__________________
"Pops" always used to say . . . you don't need to be smart, all the answers are in the books.

And when stopped for a vehicle inspection and asked why the brake pedal seemed to go just a little to close to the floor, the response was:

"I didn't buy this car to stop . . . it doesn't have anything on it that doesn't make it go faster!"

Brock Yates
Reply With Quote
  #4 (permalink)  
Old 08-14-2008, 09:44 PM
CC Member
Visit my Photo Gallery

 
Join Date: May 2005
Cobra Make, Engine:
Posts: 33
Not Ranked     
Default

Doc,

Thank you very much, I will be there. I will bring some pics of the wires in question, they come out right past where the plug in is on the computer.
__________________
Soon to have 500 HP in Spec Racer
Reply With Quote
  #5 (permalink)  
Old 08-18-2008, 12:48 PM
CC Member
Visit my Photo Gallery

 
Join Date: Feb 2006
Location: Henderson, NV
Cobra Make, Engine: FFR - 427w
Posts: 178
Not Ranked     
Default

Here's a link for you. It has all the info you need for the Ford fuel injection set up your running. http://fordfuelinjection.com/

I've been swamped with projects and not been able to get out much. If your still having problems in a week or so let me know and I'll see if I can get over there to help.

Doug
Reply With Quote
Reply

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 06:27 PM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink