03-10-2021, 01:06 PM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Quote:
Originally Posted by sgianino
Hi Patrick,
I went to put in the new PL700, even with the trim ring fully tight the bulbs are loose...would you use a rubber shim behind the Lucas tabs or shim the trim ring against the glass of the beam?
Or are there different trim ring sizes? would that be a better bet, maybe one that is not as deep that came with the car...Wasnt sure if all trim rings where the same,
Thanks
|
It should fit without having to do any shims. I bet that's not the right trim ring. If you can't get one that fits perfectly, I would opt for which ever trimming holds the bulb the most secure. Headlights get a lot of jiggling, even if you don't think they do. If they're not securely fastened, or securely shimmed and fastened, they're going to end up pointing over in to a corn field or into oncoming traffic. |
44Likes
Threaded Mode
