08-12-2018, 11:36 PM
|
 |
CC Member
|
|
|
Join Date: Aug 2009
Location: Adelaide,
SA
Cobra Make, Engine: AP 289FIA 'English' spec.
Posts: 13,152
|
|
Not Ranked
Roger,
You mentioned in another thread from around four years ago...
Quote:
Originally Posted by rsk289
....I think it's just the dash bottom compound curvature that is the problem area, and some on the ACOC have suggested steam whilst glueing it down. I have spare scraps so will practice a couple of techniques first....
|
Did you have any trouble with that radius on the lower edge of the dash (in the area around the dropped-centre?) as mentioned above?
Also, the radius into my glovebox opening is quite severe; any suggestions as to how to handle this area? I'm assuming that the most likely solution here is pie-cutting?
Cheers,
Glen |
12Likes
Threaded Mode
