02-19-2004, 11:53 AM
|
 |
CC Member
|
|
|
Join Date: May 2001
Location: California,
Ca
Cobra Make, Engine: NAF 289 Slabside Early Comp Car with 289 Webers and all the goodies. Cancelling the efforts of several Priuses
Posts: 6,592
|
|
Not Ranked
They probably will but just a word of caution, the Versaille Calipers are VERY HEAVY. That is specifically why I didn't use them, I had new ones and ultimately threw them away! I used calipers from a 88 Tbird Turbo Coupe, similar to Taurus rears too, check piston sizes, readily available cheap. Check my gallery there are some very good shots of my rear setup. I did not use them only because the "hat" area was visable behind the center of my FIA wheels, behind 427 wheel no problem. The rotors in my gallery are from a Versaille. The ones I am offering do not have as much offset, consequently they are lighter too. If you are fabricating a rear axle assembly you can make allowance for caliper location, wheel backspacing is most likely not an issue. I also have some 9" gear housings cheap.
Rick
|
Hybrid Mode
