02-23-2005, 08:15 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Sep 2000
Location: Holderness, NH, US of A,
NH
Cobra Make, Engine: CSX 4772 old iron FE
Posts: 5,499
|
|
Not Ranked
Hey Mark, one of the 427 drawings I have show good detail on the birdcage if that will help. I believe the bodies are very close as far as that goes, isn't it just a wider body with beaten out fenders? Hey sounds like you're doing a stroke of business on the CAD. I have started laying out my front suspension on CAD to check roll centers, upright dimensions etc. Where did you get your front uprights BTW they are sweet, and have you got any measurements on them yet per chance. I would like to get the front end drawing where I can bump or rebound and see what it does to toe but I'm not that good with CAD yet. If I can get it drawn I'll call in the experts from there. I took a scan of the upright drawing and put it into CAD, scaled it till I got a known dimension (like a rotor diameter) and can pull some pretty good numbers off it from there.
Cheers Nick
|
Threaded Mode
