05-23-2005, 08:52 AM
|
|
CC Member
|
|
|
Join Date: Feb 1999
Cobra Make, Engine: CSX3193, replica 289 Cobra and replica Daytona Coupe Cobra
Posts: 29
|
|
Not Ranked
289 CAD chassis drawings & rear A-arm
Hi guys,
I've been away from the forum for quite a while and just noticed this thread about chassis layouts and CAD drawings. I'm in the process of documenting all of the pieces for the original 289 rack and pinion chassis in CAD. I'm still adjusting a few of the drawings, but so far I've got approximately 100 dimensioned CAD drawings completed.
I've only had one cup of coffee this morning so all bets are off about how awake that I am, but I thought that earlier in the thread there was some questions about A-arm layouts. I don't have details of the front done yet, but I'll try to attach a copy of the rear A-arm to this post if this would be of any help.
This thread is getting very long so it would seem the idea of a forum for "scratch builders" has some apeal. Has anyone contacted Brent to see about setting this up? (I just saw Brent at an event in Reno this weekend, so he is probably still in transit back home. )
Regards,
Chuck
|
Hybrid Mode
