07-06-2005, 07:20 PM
|
|
CC Member
|
|
|
Join Date: Jan 2005
Location: Sydney,
nsw
Cobra Make, Engine: N/A
Posts: 31
|
|
Not Ranked
Hey Bob,
With a Mig you should always push the weld, the reason is a Mig is cold on start of weld so if you pull a weld you are always working away from the heat. If you are are pushing you will always be laying the wire into the heat therefore you will have better penetration. I will admit it, i can make a better looking weld by pulling, but it is not the best practice.
Steve
|
Threaded Mode
