Roll Bars

[fsiewert]

Would a few of you measure your roll bars...I'm having a hard time figuring out which bar to use. And where to order them?

Heigth from body to top of bar, diameter of bar, radius, and width from upright to upright. Both narrow single bar and double width bar would be appreciated.
Fred

[mickmate]

Height can be adjusted and should be 2" above your helmeted head. Per original it should be pretty close to 14" clear of the body. Bar diameter 1.5". Radius and width from upright to upright are the same thing 6" CLR (center line radius) and 12" centre to centre. These are the one man bars. I also have a good diagram of where the holes go through the body if you want to send me an e-mail address. I have the rollbars in 1020 DOM steel or 304 brushed stainless if you want a competitive quote.

[fsiewert]

Mickmate;
That would be great!!! That's what I need! Send the quote for the bars and the diagram to fsiewert@yahoo.com
Much thanks
Fred

[mickmate]

Hi Fred the SS one is here http://www.clubcobra.com/classifieds...duct=646&cat=4
I can do the 1020 mechanical tubing ones for $160. You'll see from the pics it is a kit with brackets, sleeving tube sizes etc. I'll e-mail you that layout info for it.