04-11-2008, 06:17 AM
|
|
CC Member
|
|
|
Join Date: Mar 2008
Cobra Make, Engine:
Posts: 85
|
|
Not Ranked
I made a quik model about body buck (see pic) just to see what it takes to modify my plans to alu-buck...
- So what you thik is this 3d-model enough sections for alu-body buck?
63Mercury: I may do dwg-drawing of each sections in 1:1 scale and sent tohose to you. Then you have to add all needed measures, radii etc info to those whaat you need. Or you may just print out those somewhere in 1:1 scale and copy to plywood like I do.
I have not yet figuret out that how to sent PM with attachmen so if you have some e-mail addres what you like to use PM it to me.
You propably use thiker plywood that what is used in these model (5mm) so you need to made large holes to x-parts for those z-parts (dont know how to explain but see pic...).
I try to look replyes during next week and depending yours comment I may continue to do these buck-drawings 
Now I will go to spend weekend bye driving snowmobile. We still had plenty of snow here. |
5Likes
Threaded Mode
