09-14-2010, 06:55 PM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
John, here is a picture of my Centerforce pressure plate when it was just temporarily bolted up to the flywheel (engine just sitting on a stand). Those little square weights that are on the fingers, and held by the circular wire. are what Rick is talking about. A lot of us pull them off. Chuck Brandt (fellow ERA owner) has a web site and he talks about the problems he had with the little weights before he removed them. If he revved hard at a stand still the clutch would start to engage and move him forward. I'm sure a search of this forum would bring up his web site and I remember that he took some shots of when he removed the weights.
Last edited by patrickt; 11-08-2016 at 12:13 PM..
|
Threaded Mode
