Torque wrench

[joyridin']

What are you going to be using the wrench for? If you are just torquing lug nuts, find a good used one or buy a cheaper new one. If you are going to be building engines and torquing head bolts etc, I would not touch a cheap version or even a used one unless you want to have it calibrated.

[blykins]

I have 3-4 different types. If you're using it to do engine work, a Snap-On, Craftsman, or similar will be sufficient. I have two that I use most of the time...a CDI 1/2" drive, and a Snap-On electronic piece. The Snap-On cost me around $450 if I remember right, but it's necessary for fasteners that use ° measurements....i.e. 30 lb-ft + 44°, etc. When it reaches torque, it beeps and vibrates, and you can cycle between the different units of measurement.

[xb-60]

Originally Posted by joyridin'

What are you going to be using the wrench for?....

Minor engine work, flywheel/clutch/gearbox etc

Thanks for the opinions so far

Cheers,
Glen