04-11-2005, 01:34 PM
|
 |
CC Member
|
|
|
Join Date: Apr 2004
Location: Scotts Valley,
CA
Cobra Make, Engine: ERA 289 FIA #2108
Posts: 1,882
|
|
Not Ranked
Chevy Tahoe question
Okay, okay, I know it's not a Cobra, but I figure somebody on CC has some knowledge on the subject. (Besides, everyone needs a tow vehicle, right?)
I need to replace the electric window motor on my driver's door on my 2001 Chevy Tahoe. I know the problem is the motor, for I've checked all of my fuses and have also determined that there is power to the switch, but no motor movement.
The problem: I've done this before on other vehicles, but it seems like every time I take the interior door panels off I rip out some of the partical board of the panel, leaving the clip in the door. I think my technique is off. I use a screw driver and pry under the panel until I find a clip, and then pry under the clip. Sound right? Perhaps I'm getting too impatient and need to work on the Zen thing...
The question: How do I remove a door panel without screwing it up, rendering the reinstallation substandard?
Doug
__________________
Dangerous Doug
"You're kidding, right?"
|
Threaded Mode
