427 burning oil-another one

GBowman · #1 (**permalink**) 05-22-2012, 02:33 PM

I read 68Pony's debacle about the seals in his FR 427, I have 1600 miles on my car now and have recently noticed a bit of gray smoke when starting and have burnt close to a qt of oil (assuming the amount between the 2 lines on the dipstick is equal to 1 qt) in approx 400 miles.

Should I be concerned? no oil is present at the tip of the sidepipes (as I believe was the case with 68Pony's car but I do see smoke on start up even when warmed up then it goes away immediately then of course the burning oil issue.

My engine is different as it is the aluminum motor with solid lifters so I was hoping to skirt this problem but now I'm not sure-thx

dallas_ · #2 (**permalink**) 05-22-2012, 03:02 PM

1st thing to do is pull the plugs and analyze them.
Does yours have the Z heads? That seems to be the culprit on the ones I'm aware of with the oil problem.

I sent my engine back to Ford and am waiting to hear back from them.

GBowman · #3 (**permalink**) 05-22-2012, 04:28 PM

Dallas-yes Z heads, how long have they had your motor? How long until they fix it? Perfect timing with the weather finally here.

mike harter · #4 (**permalink**) 05-22-2012, 04:34 PM

From Calif. 5 days to ford 5 days for repair and 5 days back I had the same problem and Ford made it right.

GBowman · #5 (**permalink**) 05-22-2012, 06:22 PM

I will call tech line tomorrow, see what they say-maybe they are finally realizing there was/is an issue. From what I got from prior posts on this issue they were trying to deflect ownership of the problem.

I bought the car new in Dec 2011 FYI

GBowman · #6 (**permalink**) 05-22-2012, 06:24 PM

Mike that is encouraging-can I ask how they had you ship the motor? did you send the complete engine? Did you fab a crate up? Which facility do they perform the repair? thx!

mike harter · #7 (**permalink**) 05-22-2012, 04:31 PM

How did you find out there was a problem with the ford Z heads. When did you buy your motor?

mreid · #8 (**permalink**) 05-25-2012, 07:11 AM

This whole issue worries me. I have two Ford Racing engines with z-heads. A 347 crate engine in my 66 Mustang and a 427 crate engine in my Kirkham. Both have been fine so far, but they also both have less than 500 miles on them.

I'm going to start another thread about z-heads and see what the experience is to date.

GBowman · #9 (**permalink**) 05-25-2012, 11:21 AM

Chris

Glad you are over that escapade, Ford has told me to check intake bolt torque and PCV as you indicated they would. I am going thru the motions as instructed so I'll keep my eye on things, won't take long to know as this weekend Ill put some mile on it for sure.

I am with you, the motor is a beast and sounds perfect-I was skepticle about going with the solid set up but man it sounds good...if there is an issue either way I will post for sure.

Thanks all.

Gary